![samsung clp 315 printer samsung clp 315 printer](https://c1.neweggimages.com/ProductImage/28-112-110-25.jpg)
The repairing was done and the customer was very happy. Glued it together with a double sided duck tape on the back side of the pcb so I got some extra mm of thickness.Īfter that I glued back to the toner and now it was aligned! Now when I closed the door there were no more light goes On and the error light was off.
![samsung clp 315 printer samsung clp 315 printer](https://farbtoner.it/images/product_images/original_images/samsung-clt-r407-clp320-opc.jpg)
I cut a piece of cardboard so it fit the dimension of the pcb. When I aligned the chips and close the door I had to push the door to make a contact. So I decided to do the followings: The printer then will shows an error message.Īnother big problem, the chips was to inserted too deep into the toner case. If this is not alligned then the contact can’t be made with the reader electronic and the chip could not be read. The vertical red lines are the position where the white arrows should be alligned on the toners. All the chip’s on the toner’s was missaligned and the toners was not original from Samsung. When I opened the front door I saw a huge problem. I decided to check the toners and all the stuff which is in charge to read the condition of the toner. A customer brought to me a Samsung CLP-315 color laser printer with the problem “ the printer refuse to use the new installed toners.” The problem is specific because sometimes all the control lights were On and sometimes only one or two lights would be turning On and off. This was a bit strange to me and I decided to try repair the printer.